Installation Steps

Stuffer Plates:

• Place all of the larger aluminum plates between the cylinders on the top side.                                                                                                                            
  
• Next place the 6" x 1/4" bolts down through the top plate.                                                                                                                 
  

• Finally put the smaller plate up through the cylinders from the bottom and secure with the lock nut.                                                    

Cowling:

 Lycoming

• Place cowling on top of engine making sure all hoses and plug wires are not in the way. 

• Fit the cowling so the mounting holes are lined up with the ears on the engine.  All engines are a little different so you may need to do a little trimming.

• Next with a 1/4" drill bit, drill through the holes in the cowling and the threaded holes in the engine. 
  

• Then take the 1 1/4" pan head bolts and put through the mounting holes and finish with the nylon lock nut on the back side.

 Continental

• Remove the two outside bolts from the top side of the valve covers.

• Next install supplied tabs to valve covers with the longer bolts.                  (As shown in picture)

• Place cowling on top of engine making sure all hoses and plug wires are not  in the way.  The cowling should be on the outside of the tabs.

•  Secure the cowling to the tabs and with a 1/4" drill bit drill through the   cowling and the tab.

• Finish by bolting cowling to all of the tabs with the 1" pan head bolts.